Repiping
Repiping el paso TX for homes that keep leaking
Repiping el paso TX means replacing every corroded galvanized or failing poly line in your walls with copper pipe or PEX tubing built to last decades. We handle whole home repiping in el paso, Texas for 1920s Sunset Heights bungalows, 1950s Lower Valley ranches, and newer Westside builds alike. If you are tired of patching the same pinhole leak twice a year, call us at +19152850728 and we will scope the job the same day.
Service overview
What repiping el paso TX actually involves
Repiping el paso TX is the full replacement of your home's potable water supply lines, not a patch on one bad section. We cut out the old galvanized steel, polybutylene, or brittle copper, then run new copper pipe or PEX tubing through the same chases and attic runs. Every joint gets soldered or pressed with a Milwaukee press tool, every line gets insulated, and the whole system is pressure-tested at 100 psi before we close a single wall. A typical 1,800-square-foot home takes three to five working days.
Most El Paso homes built before 1980 still have galvanized pipes that have been narrowing with hard water scale buildup for four decades. You notice it as low water pressure at the shower, rusty water after a vacation, or a slab leak that shows up as a hot spot on the kitchen floor. Whole home repiping el paso is the permanent fix, and it usually costs less than three or four emergency leak repairs spread across a couple of years.
Practical benefits
Why homeowners repipe instead of patch
A repipe is a one-time project that ends the cycle of pinhole leaks, rusty water, and dropping pressure. Here is what you actually get when the walls go back up.
Water pressure restored
Galvanized pipe can lose 40 to 60 percent of its interior diameter to scale. After a repipe, your shower pressure returns to what the city main delivers, usually 50 to 70 psi at the fixture. No more waiting five minutes to rinse shampoo out.
No more pinhole leaks
Copper repiping el paso homes replaces pipe that has already failed twice with pipe rated for 50-plus years. You stop paying $350 to $600 per emergency leak repair and stop worrying every time the water bill jumps.
Cleaner drinking water
Rusty brown water comes from the pipe, not the source. Once the old galvanized steel is gone, water travels through copper or PEX and arrives clear. Many customers pair the repipe with a water softener installation to keep the new lines scale-free.
Higher resale value
A documented repipe with permits on file is a selling point in El Paso County, especially in older neighborhoods where buyers expect galvanized lines. It removes an inspection objection before it ever comes up.
How service works
How our repiping process runs
Five steps, no surprises. We tell you what happens each day so you can plan around the work, and we keep the water on as long as the job allows.
STEP 01
Walkthrough and scope
We trace every supply line, check the water heater connections, and note fixture locations. You get a written scope and a fixed price the same day, usually within two hours on site. If a slab leak is suspected, we confirm it with leak detection equipment before quoting.
Tools and methods
Tools and methods we use on repipes
Milwaukee press tool
Crimps PEX and copper press fittings in seconds without an open flame. It is the reason we can run lines in tight chases without worrying about soldering near framing.
Propane torch and solder
Used for soldered copper joints where a press fitting will not fit. We keep a fire blanket on hand and check every joint with a mirror before closing the wall.
RIDGID pipe cutter
Cuts copper and PEX square so fittings seat properly. A crooked cut is the number one cause of a weeping joint, so we do not rush this step.
Leak detection equipment
Acoustic and thermal tools that pinpoint a slab leak before we quote. It tells us whether you need a repipe or a targeted repair, which saves you money either way.
Sewer camera
Inspects drain lines while walls are open. If we see root intrusion or a collapsed section, we flag it before it becomes a second project.
SharkBite fittings
Push-to-connect fittings used for temporary caps and accessible repair points. They let us restore water service overnight on multi-day jobs.
Uniform Plumbing Code (UPC) rough-in
Every repipe is laid out to UPC standards as adopted by the City of El Paso, including pipe sizing, support spacing, and protection plates where lines pass through studs. This is what the inspector checks, and it is why our rough-ins pass on the first visit.
100 psi pressure test
Before any wall is closed, we cap the system and hold it at 100 psi for at least an hour. A drop on the gauge means a bad joint, and we find it while the wall is still open instead of after you notice a stain on the ceiling.
Attic reroute for slab leaks
When a leak is under the slab, we often reroute the line overhead through the attic rather than break concrete. It is faster, cheaper, and keeps your flooring intact. We insulate the new run against summer attic heat.
Hybrid copper and PEX systems
Some homes get copper on the main runs and PEX on the branches. It balances durability where it matters with cost savings on the long runs, and it is fully code-compliant under the International Plumbing Code.
Where this service fits
When El Paso homeowners call us to repipe
A 1950s Lower Valley ranch with original galvanized pipe and a water bill that jumped $80 last month.
We run a leak detection check, confirm the loss is in the supply lines, and repipe the house in PEX over four days. The permit and inspection are handled by us. Water bill returns to normal, pressure at the kitchen sink doubles, and the homeowner stops patching pinholes every winter.
A Sunset Heights bungalow under contract where the buyer's inspector flagged galvanized supply lines.
We quote a whole home repipe with copper, schedule it inside the option period, and provide the permit record and warranty for the closing file. The deal closes on time, and the buyer gets a documented repipe instead of a credit to cover it later.
A Northeast El Paso two-story with a burst pipe during a January freeze and water running down an interior wall.
We shut the main, repair the immediate break to stop damage, then repipe the vulnerable exterior runs with insulated PEX. The wall dries out, the family is back to normal in three days, and the new insulated lines survive the next freeze.
A Westside home with a 12-year-old water heater and copper pipe showing green corrosion at the joints.
We repipe the supply lines and install a new Bradford White water heater in the same project, reusing the same permit window. One disruption instead of two, a fresh warranty on both the pipe and the heater, and no more corrosion at the joints.
Local execution
How repiping works in El Paso specifically
El Paso water is hard, averaging around 15 to 20 grains per gallon, and that mineral load is what kills galvanized pipe decades early. Homes built before 1980 in Central El Paso, the Lower Valley, and Sunset Heights are the most common repipe candidates, and we see the same pattern: scale buildup, low pressure, then pinholes. Summer attic temperatures push past 140 degrees, so any line we reroute overhead gets pipe insulation rated for the heat. Winter freezes are rare but real, and we insulate exterior runs after every repipe because a single hard freeze can split an unprotected line. If you are looking for whole home repiping el paso 24/7, we run emergency calls around the clock, and we keep SharkBite fittings on the truck to restore water the same night. Permits go through the City of El Paso, and we schedule the rough-in inspection before we close anything.
Sunset Heights
Plaster walls and original 1920s chases mean we cut smaller access holes and patch with a matching texture. Most homes here still have galvanized supply lines.
Lower Valley
Single-story ranches with long horizontal runs and slab foundations. Attic reroutes are common here because breaking the slab is expensive and disruptive.
Kern Place
Older homes with copper that has reached the end of its life. We often find green corrosion at the joints and replace the full system in copper.
Northeast El Paso
Exterior walls face hard afternoon sun, so we insulate every line we run near an outside wall to protect it from heat gain and winter freezes.
Hard water at 15 to 20 grains per gallon
Scale narrows galvanized pipe from the inside and shortens the life of copper. We recommend a water softener installation with every repipe to protect the new lines.
Summer attic temperatures above 140 degrees
Any line rerouted through the attic needs insulation rated for high heat. Without it, the first cold drink out of the tap runs warm and the pipe ages faster.
Occasional hard freezes in January and February
Exterior and attic runs are the first to split. We insulate and, where possible, reroute them inside the thermal envelope so a freeze does not become an emergency.
Problems we solve
Problems a repipe fixes for good
These are the calls we get every week in El Paso. Each one has a permanent fix, and it usually starts with replacing the pipe instead of patching it again.
Rusty brown water from every tap
We replace the corroded galvanized runs with copper or PEX, flush the system, and confirm clear water at every fixture. Most customers pair it with a water softener installation to keep the new pipe scale-free. Brown water means the inside of your galvanized pipe has corroded through. It stains laundry, ruins the taste of drinking water, and signals the pipe is close to failing entirely.
Water pressure drops when two fixtures run
A full repipe restores the interior diameter of every supply line. We size the new pipe to your fixture count and test pressure at the farthest fixture, usually landing between 50 and 70 psi. Scale buildup narrows galvanized pipe to a fraction of its original diameter. You notice it when the shower dies the moment the dishwasher kicks on, and it only gets worse.
Pinhole leaks every few months
We cut out the failing sections and replace the whole system in one permitted project. One inspection, one disruption, and a 5-year workmanship warranty instead of another patch. Each emergency leak repair costs $350 to $600 and damages drywall. When you are fixing a new one every season, you are spending repipe money in pieces without solving anything.
Slab leak with no visible source
We confirm the location with leak detection equipment, then reroute the line overhead through the attic or repipe the affected branch. You get a dry slab and a documented repair for your insurance file. A slab leak under the foundation can run for weeks before you see it. By then you are looking at a hot spot on the floor, a spiking water bill, and possible foundation damage.
A practical standard for every visit.
Clear planningPrepared arrivalsCareful workLocal follow-through
Experience in the details
Local repiping experience you can check
Our technicians hold Texas State Board of Plumbing Examiners (TSBPE) licenses, including Master Plumber and Journeyman Plumber credentials, and we carry Backflow Prevention Assembly Tester certification for the work that requires it. Every repipe is permitted and inspected under the Uniform Plumbing Code and International Plumbing Code as adopted by the City of El Paso. We work on galvanized, copper, polybutylene, and PEX systems across El Paso County, from pre-war bungalows to 1990s two-story builds. We are licensed, insured, and bonded, and we warranty our repipe labor for 5 years.
- TSBPE-licensed Master Plumber and Journeyman Plumber on every repipe crew.
- Permits and rough-in inspections handled with the City of El Paso, not skipped.
- Copper, PEX, and hybrid systems installed to UPC and IPC standards.
- Slab leak and pinhole leak diagnosis with leak detection equipment before any quote.
- Water heater, softener, and filtration hookups included when you repipe.
Where we work
One local team. A lot of ground covered.
Downtown El PasoSunset HeightsManhattan HeightsKern PlaceFive PointsEastsideNortheast El PasoWestsideCentral El PasoLower ValleyHorizon CityMontwood
Check my address Notes from local customers
What El Paso homeowners say
Our 1928 house had galvanized pipe that was rusting through every winter. The crew repiped the whole place in four days, patched the plaster, and even reconnected our water heater. Water pressure at the shower is better than it has ever been. They left the yard cleaner than they found it.
We had three pinhole leaks in 18 months and finally gave up on patching. They quoted a whole home repipe with PEX, pulled the permit, and passed inspection on the first try. The price was what they said it would be, no add-ons. Should have done it two years ago.
A slab leak showed up as a hot spot on our kitchen floor. They used leak detection equipment to confirm it, then repiped the house in copper. The crew was on time every morning and cleaned up each day. Five-year warranty on the labor, which sold us.
Most whole-home repipes in El Paso run $4,500 to $12,000 in 2026, depending on square footage, pipe material, and how many fixtures we reconnect. A single-story 1,500-square-foot ranch with PEX typically lands near the low end. Copper costs more in material but lasts longer. We give you a fixed written price after a same-day walkthrough, and that number includes permits and drywall patching.
We do, and we are licensed by the Texas State Board of Plumbing Examiners. Our crews handle whole home repiping near me in el paso for old pipes in Sunset Heights, Kern Place, the Lower Valley, and Northeast El Paso. We pull the permit, run copper or PEX, pressure-test at 100 psi, and pass the city inspection before we close walls. Call +19152850728 to schedule a walkthrough.
A typical El Paso home takes three to five working days from rough-in to final fixture hookup. Larger two-story homes or jobs with heavy slab work can stretch to seven days. The water is usually off for six to eight hours on the heaviest day, and we tell you the night before so you can plan. Drywall patching and cleanup happen on the last day.
Insurance rarely covers the repipe itself because it is considered maintenance, but it often covers water damage from a sudden burst pipe. In El Paso, where hard water scale and slab leaks are common, most carriers treat gradual corrosion as excluded. We document the failure with photos and a leak report you can submit with your claim. Ask your adjuster before authorizing repairs.
Keep exploring
Related Services
Your next step is waiting
Get your repiping el paso TX quote today
We are licensed, insured, and bonded, and we give you a fixed price before we open a wall. Call +19152850728 and we will schedule a same-day walkthrough for your repipe.
Start with the basics
Contact plumbing in el paso
Call us at +19152850728 any time, day or night. For non-emergency work, we schedule Monday through Friday and offer Saturday appointments. You get a real arrival window and a text when the tech is on the way. Email works too if you prefer to send photos of the problem first.